Water Filtration System; Refrigerator Care; Cleaning; Changing The Light Bulb - IKEA NUTID Installation And User Instructions Manual

Water Filtration System

The water filter is located in the upper right-hand corner of the
refrigerator compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
IMPORTANT: The disposable water filter should be replaced at
least every 6 months. If the water flow to the water dispenser or
ice maker decreases noticeably before 6 months have passed,
replace the water filter more often.
Replacing the Water Filter
To purchase a replacement water filter, model
UKF8001AXX-750 or UKF8001AXX-200, contact your dealer or
call 1-866-664-2449 U.S.A. or Canada.
IMPORTANT: Air trapped in the water system may cause water
and filter to eject. Always dispense water for at least 2 minutes
before removing the filter or blue bypass cap.
1. Turn filter counterclockwise to remove.
2. Remove sealing label from replacement filter and insert the
filter end into the filter head.
3. Turn the filter clockwise until it stops. Snap the filter cover
closed.
4. Flush the water system. See "Water Dispenser."
NOTE: The dispenser feature may be used without a water
filter installed. Your water will not be filtered. If this option is
chosen, replace the filter with the blue bypass cap.

REFRIGERATOR CARE

Cleaning

WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Both the refrigerator and freezer sections defrost automatically.
However, clean both compartments about once a month to
avoid buildup of odors. Wipe up spills immediately.
IMPORTANT:
Because air circulates between both sections, any odors
■
formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid
odor transfer and drying out of food, wrap or cover foods
tightly.
For stainless steel models, stainless steel is
■
corrosionresistant and not corrosion-proof. To help avoid
corrosion of your stainless steel, keep your surfaces clean
by using the following cleaning instructions.
To Clean Your Refrigerator:
NOTE: Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, muriatic acid,
cleaning waxes, concentrated detergents, bleaches or
cleansers containing petroleum products on exterior surfaces
(doors and cabinet), plastic parts, interior and door liners or
gaskets. Do not use paper towels, scouring pads, or other
harsh cleaning tools.
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
3. Clean the exterior surfaces.
Painted metal: Wash painted metal exteriors with a clean,
soft cloth or sponge and a mild detergent in warm water.
Rinse surfaces with clean, warm water and dry immediately
to avoid water spots.
Stainless steel: Wash stainless steel surfaces with a clean,
soft cloth or sponge and a mild detergent in warm water.
Rinse surfaces with clean, warm water and dry immediately
to avoid water spots.
NOTE: When cleaning stainless steel, always wipe with the
grain to avoid cross-grain scratching.
4. There is no need for routine condenser cleaning in
normalhome operating environments. If the environment is
particularly greasy or dusty, or there is significant pet traffic
in the home, the condenser should be cleaned every 2 to 3
months to ensure maximum efficiency.
If you need to clean the condenser:
Remove the base grille.
■
Use a vacuum cleaner with a soft brush to clean the
■
grille, the open areas behind the grille and the front
surface area of the condenser.
Replace the base grille when finished.
■
5. Plug in refrigerator or reconnect power.

Changing the Light Bulb

IMPORTANT:The light bulbs in both the refrigerator and
freezer compartments use LED bulbs, incandescent bulbs or a
combination of the two.If the lights do not illuminate when the
refrigerator and/or freezer door is opened, call for assistance or
service.See "Warranty" for phone numbers.
1. Unplug the refrigerator or disconnect power.
2. Remove the light shield (on some models).
Top of the refrigerator compartment - Slide the light
■
shield toward the back of the compartment to release it
from the light assembly.
3. Replace the burned-out bulb(s) with a bulb of the same size,
shape and wattage.
To replace a burned out LED bulb with a LED bulb, order
■
Part Number W10565137 (3.6 watts).
Note: Some LED replacement bulbs are not recommended
for wet/damp environments.The refrigerator and
freezer compartments are considered to be wet or
damp environments.If using a brand of LED other than
recommended LED bulb, before installation, read and follow
instructions on the LED packaging.
When replacing an incandescent bulb, use only
■
incandescent bulbs for household appliances with a
maximum of 40 watts. Replace bulb shield/shroud after
replacing incandescent bulb.
4. Replace the light shield.
5. Plug in refrigerator or reconnect power.
15