Table of Contents
Advertisement
155
Outline of front cover
Figure 3-4: Solo CompactMAX fixing holes (viewed from the
front)
11. Connect the heating system flow and return pipes to the
corresponding flow and return connections on the Solo fan
convector unit via the isolation valves.
12. Connect the electrical supply to the Solo fan convector unit.
Refer to Section 4 (Electrical).
13. When all the Solo fan convectors have been connected to
the system pipework, the system can be filled.
14. Once the system is filled, open the HIGHEST of the two
bleed screws on the flow pipe to vent the fan convector heat
exchanger. Repeat this with all other fan convectors on the
system.
15. Refit the front cover and secure along the lower front edge
using the three screws previously removed.
16. When all the installation of all the Solo fan convectors has
been completed they can be commissioned. Refer to Section
5 (Commissioning).
section 3: installation
90
65
985
3.8
instaLLatiOn PROCEDURE:
sOLO HiDEaWaY mODEL
Accurately mark and cut the opening required in the plinth or
panel into which the Grant Solo Hideaway unit is to be fitted. The
bottom edge of the opening MUST be at least 12mm above the
finished floor level.
Refer to Figure 2-7 for the dimensions of the opening.
410
Figure 3-5: Solo Hideaway cut-out and fixings holes
If the height of the opening above floor level is greater than
12mm, it may be necessary to place packing under the two
rubber feet at the rear of the fan convector to support the
unit.
Carefully remove the Solo Hideaway fan convector unit from the
packaging and lay it on a flat surface.
Unscrew and remove the four fixing screws. Refer to Figure 2-8.
Keep these screws in a safe place as they will be required later to
re-fit the grille.
Figure 3-6: Solo Hideaway grille fixing screws
Carefully remove the grille and lay it flat in front of the unit.
Disconnect the control panel ribbon connector from the plug.
Refer to Figure 2-9.
! nOtE !
Page 9
Hide quick links:
Advertisement
Table of Contents
