Grant SV200 Quick Start Manual

SV200 Universal Stirred Heater for sous vide cooking

Important Safety Information

• A £1,000 cash prize
• Read this quick start guide in full. Safety may be impaired if it is not followed.
• Promotion on the Grant website
• Only connect to the voltage and frequency shown on the serial number plate. An earth is required.
• The SV200 is designed for use with water only.
• Safety can only be assured if the SV200 is clamped firmly to a vessel with suitable stability and
robustness and placed on a level non-combustible surface.
• Ensure the SV200 is positioned so that the plug is easily accessible for disconnection.
• Before moving or cleaning, allow the unit to cool down and disconnect from the power supply.
• When using the SV200 at temperatures above 60˚C, use a cover where possible to avoid excessive evaporation.
• The alarm light warns that the SV200 is in a state that could be cause harm. Care should be taken when investigating
the warning.

Features

• A £1,000 cash prize
• Promotion on the Grant website
1
2
3
6

Setting the temperature

1.
Press S: Display Rotate dial to
will flash desired temp

Quick start guide

4
5
7
8
1. 1.
Press S: to
store value
Features
1. Alarm light
Display
2.
3. F (function) button
4. Heater on light
5. S (select) button
6. Dial
7. Clamp and cage
8. Float: low liquid level protection

Setting a countdown timer

1. Press F twice – the display will show "Cloc".
Press S to select.
2.
3. Rotate dial to select "On". Press S to select. The
display flashes with time (in minutes) rotate the dial to
set time required (1 to 6000min).
4. Press S to save. The display alternates between
bath temp and time remaining.
5. An alarm will sound when the countdown timer
reaches zero. "End" will be displayed. Press F or S
to accept.
www.grantsousvide.com
s o u s v i d e