bOOst FUnCtiOn
The boost function is activated by pressing the Boost button
on the control panel fascia. Refer to Section 10 - Operating
Instructions.
The boost function overrides the normal temperature control and
runs the fan at higher 'Boost' level for a period of 20 minutes to
provide a greater heat output than the normal operation.
After this period has elapsed the Solo unit automatically returns
to the normal temperature control with the fan operating at either
'Low' or 'High' setting as dictated by the difference between the air
temperature and the air temperature setting on the unit.
1.3
COntROL PanEL OVERViEW
Grant Solo fan convectors are supplied with a simple control
panel. Refer to Figure 1-3 and Section 8.2 (control panel).
ON/OFF
Special function
button
light
Temperature indicator lights
Alarm light
Boost / cool button
Figure 1-3: Solo fan convector control panel overview
section 1: introduction
Page 5