Lanyard Post 15V/1A Recharge (Input) Port Smarty Clamps ® CHARGE UP YOUR WEEGO 44 When you unpack your new Weego 44 for the first time, Indicator charge it up to 100% with either the wall or car charger Lights Sequence: provided.
NEUTRAL). TURN OFF ALL ELECTRONICS! – air conditioner, radio, lights, etc. Remove any devices attached to your Weego 44. Never leave your Weego 44 connected to your engine’s battery unless actively jumping. ® Always disconnect the Smarty Clamps from your Weego 44 when not in use.
Page 4
Connect Clamps Power ON Attach Black (-), Then Red (+) When You Have FLASHING GREEN LIGHT On Your Smart Box, Start Your Engine Once it Starts, Disconnect Clamps Detach Clamps From Battery from Weego 44...
Page 5
Clear off any dirt or build-up with a wire brush or a dry towel before connecting your clamps. Place your Weego 44 in a secure location or suspend using the provided hook & lanyard so it won’t fall. Check your Smarty Clamps lights.
POSITIVE (+) attached to the battery’s terminal. If not attached properly, Weego 44 will not let you jump your engine. Flashing Red Light + Beeping COOL DOWN WAIT FOR The Weego battery overheats after long cranks or excessive current draw.
Weego to deliver its full power. • Low-Charged Weego: it’ s always best to work with full power on your Weego if you can. Our jump starters perform better at 100% charge than they do at...
Need help?
Do you have a question about the 44.1 and is the answer not in the manual?
Questions and answers