Table of Contents
Advertisement
Quick Links
Current
Tools™ Hydraulic Punch Drivers
Model 170 PM – Str. Hyd. Punch Driver Set
with 1/2"
to 2" Punches and Dies
Model
179 PM – 90° Hyd. Punch Driver Set
with 1/2"
to 2" Punches and Dies
Operating, Maintenance, Safety
and Parts Manual
This manual is free of charge. All personnel who operate the
Hydraulic Punch Driver Set should have a copy of this
manual and read and understand its contents. To request a
copy, call or write to the address below.
CURRENT TOOLS • P . O. BOX 17026 GREENVILLE, SC 29606
800.230.5421 or 864-721-4230 • FAX 864-721-4232
Read and understand this material before
operating or servicing any component of
the Hydraulic Punch Driver Set. Failure to
understand how to safely operate and service
this unit may result in serious injury or death.
www.currenttools.com
10/09 -
REV. 1
Advertisement
Table of Contents
Related Manuals for Current Tools 170 PM
Summary of Contents for Current Tools 170 PM
- Page 1 Hydraulic Punch Driver Set should have a copy of this manual and read and understand its contents. To request a copy, call or write to the address below. CURRENT TOOLS • P . O. BOX 17026 GREENVILLE, SC 29606 800.230.5421 or 864-721-4230 • FAX 864-721-4232 www.currenttools.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Alerts ......... . 2 Safety Information . -
Page 3: Safety Information
RETAIN SAFETY INFORMATION This manual should be read and understood by all personnel who operate or service this Hydraulic Punch Driver Set. Failure to understand how to safely operate and service this unit could result in injury or death. This unit should only be operated or serviced by qualified personnel. -
Page 4: Specifications
) stainless steel — 1/2” to 1 1/4” conduit size holes .134 in. thick Current Tools™ Models 170PM and 179PM — Piece Makers™ — are designed to split the slug into two pieces for easy removal from the die after punch completion. -
Page 5: Operating Instructions
OPERATING INSTRUCTIONS B E N D I N G Match the punch, die, draw stud, adapter ( if needed ) , and spacer as required for the size hole to be punched. ( See SET-UPS page 6. 2. After marking the hole location, drill a hole approximately 1/32” to 1/16” larger than the draw stud being used. -
Page 7: Maintenance
MAINTENANCE B E N D I N G Requirements: We recommend a high quality automatic transmission fluid such as Shell DONAX TG or equivalent Filling the Punch Driver with Oil: 1. Secure the pump in a vise by clamping lightly onto the hex body with the reservoir and end cap facing upward, and unscrew the end cap. -
Page 8: Components List
COMPONENTS PUNCH DRIVER SETS COMPONENTS LIST B E N D I N G ITEM# CATALOG# DESCRIPTION #170 #170PM #179 #179PM 1/2” to 2” 1/2” to 2” 1/2” to 4” 1/2” to 4” ..1 ....1700 ....Punch Driver - Straight ....1....1..........2 ....1790....Punch Driver - 90°............1....1 ..3 ....1701 .......Plastic Case......1....1....1....1 ..4 ....1702.....3/4”...
Need help?
Do you have a question about the 170 PM and is the answer not in the manual?
Questions and answers