Advertisement
Using your machine
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum).
• Pre motor filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the machine is stood in the upright position.
NOTE: The brushbar will not spin until the machine is reclined.
Using accessories
NOTE: The TurboTool, 3-in-1 crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube
or directly to the hose.
Use the tool connector when attaching the flexi crevice or flat upholstery tool (some models only).
Attaching the hose
Remove hose end
Choose an accessory.
from the floorhead.
Telescopic extension tube
Remove telescopic
Attach hose to telescopic
extension tube.
extension tube.
a
b
c
3-in-1 tool converts into:
Attach accessory
a = Crevice tool
to hose end.
b = Upholstery tool
c = Dusting brush
Attach accessory to
telescopic extension tube.
Taking care of your machine
How to use the air vent
Slide vent cover open to decrease suction,
if required on high piled carpets.
NOTE:
For most efficient results the air vent should be closed.
Emptying and cleaning the dirt container
Press the dirt container release button and pull
to remove the dirt container.
Cleaning the HEPA pre-motor filter
Turn the dirt container lid
...and lift to remove.
anti-clockwise...
!
!
Tap the filter over a bin
Wash the filter under
to release any dirt.
running water (40°C max).
Close the vent cover to increase suction,
for maximum cleaning on hard floors.
Hold dirt container over a bin and press the dirt
container release button allowing dirt to fall out.
Grasp tab on filter
and pull to remove.
24hr
40˚C
40˚C
!
!
MAX
MAX
!
40°C max
Leave to fully dry for at
least 24 hours before
putting back into the
vacuum cleaner.
Advertisement
