Neck Belt - Filtec OV-II Maintenance, Troubleshooting And Service Manual

OV-II Maintenance, Troubleshooting and Service Manual

NECK BELT

3-10
1. Raise the Inspection Head an remove the starwheel.
2. Remove the three philip head screws. See figure below for screw
location.
3. Remove the lens retaining ring and replace the finish lens.
4. Place retaing ring back in postion with the three screws removed in
step 2.
To replace the Neck Belt proceed as follows:
1. Raise the Inspection Head.
2. Remove the old neck belt and replace with a new belt.
3. Lower the Inspection Head and manually pass a bottle on the
starwheel through the inspection area.
Industrial Dynamics Company, Ltd. © Form 42600 (10/03)