Repair And Replacement Procedures Overview; Guidelines For Repair Or Replacement - Filtec OV-II Maintenance, Troubleshooting And Service Manual

REPAIR AND REPLACEMENT PROCEDURES
OVERVIEW
NOTE
WARNING

GUIDELINES FOR REPAIR OR REPLACEMENT

Industrial Dynamics Company, Ltd. © Form 42600 (10/03)
The following procedures outline the step-by-step instructions for
repairing or replacing Omnivision components. Read the complete set of
instructions for each component to be repaired or replaced before
performing the procedure. Follow the instruction sequence as outlined.
Industrial Dynamics Company (IDC) does not recommend field-
repairing any electronics cards and modules. Any attempt by
customers to field-repair electronics cards and modules may void the
Omnivision's warranty provisions. If you have any questions about
repairs and warranty, contact IDC.
TURN OFF ALL ELECTRICAL POWER BEFORE REPAIRING
OR REPLACING ANY OMNIVISION COMPONENTS. FAILURE
TO DO SO MAY RESULT IN DAMAGE TO THE MACHINE AND
ELECTRICAL SHOCK, CAUSING SERIOUS BODILY INJURY.
Before repairing or replacing any Omnivision components, observe the
following general guidelines:
1. Handle all Electrostatic Sensitive Devices (ESD) such as electronic
parts, circuit cards and modules, in static-free work areas. Keep work
areas free from plastic wrappers, styrofoam materials and rubber
mats, etc. Wear anti-static wrist straps.
2. Do not make repairs on the electronic cards and modules.
3. Do not remove or insert any electronic cards, modules, plugs, jacks or
connectors with power applied to the unit.
4. Do not force electronic cards and modules into place.
5. Be sure the electronic cards and modules are installed in proper
locations.
6. Store all spare electronic components and assemblies in a safe, dry
area.
Chapter 3: Repair & Replacement Procedures
3-1