b Tighten the 4 captive screws to secure the heat sink assembly to the system board.
NOTE:
Tighten the screws in a sequential order (1,2,3,4) as shown on the heat sink label.
CAUTION:
NOTE:
Ensure that the screw is tightened completely before moving on to the next screw.
2
Install the:
a
Air duct
b
Top cover
3
Follow the procedure in
Processor
Removing processor
1
Follow the procedure in
2
Remove the:
a
Top cover
b
Air duct
c
Heat sink
3
To remove the processor:
a
Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
b Lift the lever upward and lift the processor shield [2].
c
Lift the processor out of the socket [3].
40
Removing and installing components
Ensure that the heat sink is held parallel to the system board to prevent damaging the components.
After working inside your
Before working inside your
computer.
computer.