Installation - Gabarron GTC-30 Installation Instructions And User Manual

3.- INSTALLATION

ACCESORIES
The electric water heater is supplied with insulating dielectric bushings and with a safety valve. These
items are in the packaging.
LOCATION
Both the wall to which the immersion heateris installed and its retaining screws and blocks must be
able to bear the weight of the appliance when filled with water.In the case of a thin wall, counterplates
must be used on the other side of the wall.
N.B.- The immersion heater must be installed in such a way that the plug of the power cable is
accessible.
The option of installing the immersion heater horizontally or vertically makes it easy to install it
anywhere in the house.However, it is recommended to place it as close as possible to the point where
the hot water will be used; this will avoid temperature losses of the water as it goes through the pipes.
When the immersion heater is installed vertically, leave a minimum space of 50 cm under the pipe
outlet, to be able to access the electrical parts and make it easier to service and repair.
When it is installed horizontally, the immersion heater must always be on a wall or vertical plane with
the inflow and outlet pipes laid out as indicated in Figure 1. When it is installed horizontally, the hot
water outlet must be in the upper part of the immersion heater.
If it is near to a wall, leave a space of 50 cm so that the electrical parts can be accessed and making
it easier to service and repair. Never install the immersion heater horizontally with the wall brackets on
the floor or on a roof or horizontal plane.