Locosys GW-60 Quick Start Manual page 6

LOGGING: Log rate setting.
3.5
OFF : No logging.
1HZ : When speed over [MIN SPEED], log rate in 1HZ.
5HZ : When speed over [MIN SPEED], log rate in 5HZ.
SMART:
When speed over [MIN SPEED] but less than [SPD
GENIE], 1 HZ log rate.
When speed over [MIN SPEED] but more than [SPD
GENIE], 5 HZ log rate.
Note: This saves memory at low speed and gives more
precious data where it's needed, but some software uses
changes in log rates as an error filter. This may cause alphas to
be rejected if log rate changes during the gybe.
MIN SPEED (MIN SPD): Speed threshold, only logged
3.6
speed above [MIN SPEED].
Available number: 0 to 15 [UNIT].
Sets the speed when logging starts. Under [MIN SPEED]
there is no logging.
UNIT: Speed measurement unit.
3.7
KM : Kilometer.
MI : Mile.
NM : Nautical mile.
6
www.locosystech.com