Table of Contents
Advertisement
UNPACKING
Unpack the product and check for any damage incurred during
transit. This should be reported to the responsible carrier, railway or
postal authority, and a request for a damage report should be made.
THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO
GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR
PROTECTING AGAINST LOSS FROM CONCEALED DAMAGE.
THE FORM FOR FILING SUCH A CLAIM WILL BE PROVIDED
BY THE CARRIER.
These appliances are intended for use with LPG at a pressure of
2.8kPa.
Regulators used with this appliance must comply to SANS 1237 and
be approved by the LPGASA. Only regulators certified for operation
at 2.8kPa must be used on these appliances.
GENERAL INSTALLATION AND OPERATION INSTRUCTIONS
1. This appliance should only be used in a WELL – VENTILATED
ROOM. Adequate ventilation allows for the removal of the
products of combustion and allows the entry of replacement air.
2. This appliance has a factory set fixed primary air intake and
no adjustment is necessary. No adjustments to jets or air intakes
should be undertaken unless carried out by a factory approved
agent.
3. The Installation of appliances may only be carried out by a
registered installer and such installations shall comply with the
requirements of SANS 10087-1
4. Make sure that all connections are gas tight by brushing with
a soapy water or liquid detergent (a gas leak will form bubbles).
If bubbles form, close cylinder valve and hand tighten all fittings
again. IF BUBBLES STILL FORM, DO NOT USE THE APPLIANCE.
Have a dealer check the appliance.
1
14
Advertisement
Table of Contents
