Table of Contents
Advertisement
VX-4000 Operating Manual
How to Select Channels to be Scanned
If your radio has been configured by your Dealer to allow you, the operator, to make
changes to the list of channels to be scanned, you can make these changes by following
this simple process:
À Press and hold in the SEL button; while holding this button in, press the POWER
button to turn the radio on. You may now release the
Á Press the
??
button, as necessary, until the Memory Group and Memory Channel
numbers will appear in small characters in the right side of the display area.
 You may now push the
the Memory Group within which you wish to make changes to the channel scan
list. Once you have selected the desired Memory Group, you may use the UP (p)
or DOWN (q) button to choose a particular channel within the current group.
Pressing the
??
button will change the scanning status of the selected channel.
If you are adding the channel to those you wish to scan, pressing the
causes a "U" appear on the display, indicating that the channel has been added to
the User Scan List. If you are deleting the channel from the User Scan List (the
channel's data itself will not be deleted; the channel just will not be scanned), the
"U" will disappear.
à Repeat step 3 for each channel you wish to enable or disable for scanning.
Ä When you are done making changes to the channels you wish to scan, press and
hold in the
??
button for more than 1.5 second. Operation will return to its normal
status, and the display will revert to its previous appearance.
Page 8
??
key momentarily as many times as necessary to choose
??
button.
??
button
Advertisement
Table of Contents
