Front Panel Navigation - Crown XTi 2002 Operation Manual

XTi2 Series Power Amplifiers

Front Panel Navigation

From the front panel, you can change settings for several of the amplifier's integrated signal processing
features: Input Y, Crossover Frequency, EQ, Delay, Limiting, and Stereo/Bridge-Mono. The Icons in the display
illuminate to show which features are currently applied and turned on.
When you power-on the amplifier for the first time, the LCD screen displays "DSP OFF" (no DSP is applied).
Subsequent power-ons display the preset that was active when you last shut off the amplifier.
The figure below shows the Menu Tree, which is the navigation path of options in the Menu. It shows how
you navigate through the front panel and which settings are available from the front panel. For full access to
all features, it is required that you hook up the amplifier via USB to a computer and run either HiQnet System
Architect™ or Band Manager™ software. Both are available free via download from the following address:
http://hiqnet.harmanpro.com.
Menu Tree
Power-up
CURRENT PRESET
Sel
FLASHING "PRESET" TEXT
Sel
FLASHING "PRESET" ICON
Sel
PRESETS
(TEXT on screen)
DSP OFF
Next
BRIDGE
Next
XOVER
Next
BRG SUBS
Next
SUB SYNTH
Next
USER PRESETS
6-50
Next
Sel
Doing nothing returns you to the
CURRENT PRESET after a timeout delay.
Starting from the CURRENT PRESET,
Sel > Sel > Next goes to presets.
Sel > Next > Sel lets you
configure the DSP processes.
Navigating the LCD Screen Menu: Basics
To step through the Menu options, press the Sel, Next or Prev buttons as described in the menu tree above.
Icons illuminated at the top of the screen show which DSP functions are active with the current preset.
When you are modifying a preset, its icon flashes. You can scroll through its settings with the Prev and Next
buttons. When you see the desired setting, select it by pressing Sel. Doing nothing returns you to the current
preset after ten seconds.
In the LCD screen, if the Preset Icon is lit, the current preset is unchanged from its stored settings. If the
Custom Icon is lit, the current preset has been changed from its stored settings.
Operation Manual
MENU TREE
Next or Prev
FLASHING "CONFIG" TEXT
Sel
Next
DSP PROCESSES
(ICONS on screen)
Y
Sel
XOV
Sel
EQ Ch. 1
Sel
EQ Ch. 2
Sel
DELAY Ch. 1
Sel
DELAY Ch. 2
Sel
LIM Ch. 1
Sel
LIM Ch. 2
Sel
STEREO/BRIDGE MONO
Sel
Press Next to see
CH1+CH2
each processor's
Next Next
INPUT Y
options, then press
STEREO
Sel to select an option.
Next
OFF, 90 Hz, 100 Hz, 1200 Hz,
1500 Hz, 2000 Hz, 2-CH SUB,
CUSTOM
Next
EQ OUT
EQ IN
Prev
Next
EQ OUT
EQ IN
Prev
Next
CURRENT, OFF, 50, 40, 30,
20,10, 9, 8, 7, 6, 5, 4, 3, 2, 1
Next
CURRENT, OFF, 50, 40, 30,
20,10, 9, 8, 7, 6, 5, 4, 3, 2, 1
Next
CURRENT, OFF, –0.5 dB,
–1.0 dB, –1.5 dB... –40 dB
Next
CURRENT, OFF, –0.5 dB,
–1.0 dB, –1.5 dB... –40 dB
Next
BRIDGE
STEREO
Prev
page 11