Advertisement
INSTALLATION
How To Install The Diverter Body
Remove the parts according to the following order: ratchet ring(2),
escutcheon(3) and washer(4). Insert the side body with washer(5) and
nut(6) through mounting hole from underside of the deck. Reinstall the
parts according to the following order: washer(4), escutcheon(3) and
ratchet ring(2). Adjust the side body's height above the deck according to
the adjustive cardboard(1). Wrench tighten the nut(6).
Note: When installing the diverter body, the end with the check valve is
towards the side of the hole for handspray.
How To Install The Diverter Handle
Place the handle(7) onto the diverter body. The correct status of the
handle in the middle position is as shown in the figure.
How To Install The Handspray And Hoses
Remove the nut(11), washer(10). Put the rubber washer(9) into the
groove of the escutcheon(8). From underside, install the washer(10) and
nut(11) to the escutcheon. Then tighten the nut firmly.
Slide the hose(14) through escutcheon(8), and attach to the hose(15).
Put the restrictor(13) in the handspray(12) inlet. Connect the hose(14) to
the handspray.
1070390-2A-C
1
2
4
3
5
6
7
8
9
10
11
12
13
14
8
15
2
Spout
Cold
Hot
Put the fiber washer into connecting nut of the hose(15), then thread the nut to the end with check-valve of
diverter(18). Put the fiber washer into each connecting nut of the hose(17), then connect the Tee(16) and inlet
end of the diverter. Connect the spout and the other end of the diverter with the hose(19)(Provided with the
deck-mount bath faucet 16390). Tighten all the connecting nut.
To ensure the water flow smoothly and the handspray can be drawn out easily, the hose should avoid kinking,
twisting.
Note: The end with the check valve of diverter must be connected to the handspray. Hoses should only be
used where defined.
INSTALLATION CHECKOUT
Ensure that all connections are tight. Ensure that the handle is in the off
position. Remove the handspray(12). Open the drain. Turn on the main
supply and check for leaks. Open both hot and cold valves and run water
through the spout to remove any debris. Turn the valve off. Reinstall the
handspray.
Gently rotate the handspray head. You can get three different flows
signed on handspray head.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1070390-2A-C
12
16
17(100cm)
18
15
19(100cm)
12
3
Advertisement
