Reversing Door Instruction - Marathon MBWC24 Owner's Use And Care Manual

Reversing the Door Swing
For models MBWC24, MWC24-D1:
Due to the handle location, your Marathon wine and/or beverage cooler is factory set for
Right Hand Hinge only and is not reversible. Please contact www.stirlingmarathon.com for
door exchange options if a Left Hand Hinge door is required.
For model MWC24-DBLS:
Please follow the directions below:
Step 1 Place the wine cooler in an open area allowing the door to be opened to the
maximum angle and free from obstruction.
Step 2 Use a thin knife or
screwdriver (2) to remo-
ve the 3 plastic hole co-
ver caps (1). Keep these
caps for Step 7.
Step 3 Use a hex key to
remove the screws of the
door support. Remove
the door support.
Step 5 Remove the up-
per and lower hinges
using the hex key. Re-
position the upper and
lower hinges on the
other side of the cabinet
and install them using
the hex key.
Step 6 To install the door
on the other side, simply
flip the door 180 degrees
and position in the door
hinges using the door
shaft and screws in step 4.
A
C D

Reversing door instruction

Step 4 While holding the
door, use a hex key to
remove the door shaft
from the top and bottom
of the door. Gently re-
move the door and set
aside in a safe place.
Step 7 Install the hole co-
ver caps removed in step
2 to cover the 3 holes on
the side where the door
was removed. Using the
hex key, reinstall the door
support on the opposite
side of the wine cooler.
Adjust accordingly to
provide good support so
the door can freely open
and close.
B
9