Weston 01-0201 Instructions Manual page 6

PASTA MACHINE ASSEMBLY
1. Position the Pasta Machine Base
on a table or countertop, near the
edge of the work surface.
2. Slide the C-Clamp into the
C-Clamp port in the side of the
Pasta Machine Base. The threaded
screw portion of the C-Clamp will be
underneath the table or countertop.
FIGURE A
3. Tighten the Thumbscrew on
the C-Clamp to secure the Pasta
Machine to the table or countertop.
FIGURE B
4. Align the Clips of the Cutter
Attachment with the Clips on the
Pasta Machine. Slide the Cutter
Attachment onto the Pasta Machine
until fully seated. FIGURE C
5. Align the notches on the Handle
with the notches in the Drive Slot of
choice. Slide the Handle into the
Drive Slot of the Roller or the Cutter
Attachment to be used.
FIGURE D
NOTE: Be sure to notice when the
Handle turns, it passes below the
edge of the work surface and turns
freely, it should not hit the work
surface. If the Handle comes in
contact with the work surface, loosen
the C-Clamp and reposition the
Pasta Machine to allow more space.
FIGURE E
6
FIGURE D
Spaghetti Cutter
Drive Slot
Fettuccini
Cutter
Drive
Slot
Roller
Handle
Drive Slot
Base
C-Clamp Port
Cutter Attachment
Clips
FIGURE A
C-Clamp
FIGURE B
C-Clamp
Thumb-
screw
FIGURE C
Clips
FIGURE E