Before Installation; Required Tools - Mazda C860 V7 281A Installation Instructions Manual

3. BEFORE INSTALLATION

REQUIRED TOOLS


☆Screwdriver (Flathead)
☆Box-end wrench/Combination wrench
☆Pliers
☆Punch
☆Flathead screwdriver wrapped with protective tape
☆Round file
☆Soft clean cloth
☆IPA (Isopropyl alcohol)
WARNING
If the negative battery is
connected while performing the
work, it may cause electrocution
or other personal injuries.
Disconnect the negative cable
before /installation.
When connecting/disconnecting
connectors, grasp the connectors,
not the wires. Otherwise, a fire or
other accident could occur due to
a short circuit or poor contact.
CAUTION
Be sure to cover the vehicle body
with protectors or mats to prevent
stains, scratches and damage
when removing/installing the
vehicle parts.
Wrap protective tape around
screwdrivers and fastener
remover tools to prevent
scratching the vehicle.
Make sure to remove burrs from
the surface so that the bumper
surface is smooth.
Advice
Refer to the Workshop Manual
for removal and installation of
vehicle parts.
☆Screwdriver (Phillips)
☆Torque wrench
☆Hole saw (20mm)
☆Pincers
☆Fastener remover wrapped with protective tape ☆Flat, round file
☆Deburring Tool
☆Electrical vinyl tape
Before performing any work,
park the vehicle on level ground,
apply the parking brake
securely, and then block the
wheels.
Make sure the connector is
securely pressed in until a click
sound is heard.
Otherwise, a fire or other
accident may occur due to an
open circuit or poor contact.
Using improper tools may
damage parts. Use the correct
tool for the job.
If there is dust, dirt or grease on
the adhesion surface, the
adhesive strength of the
double-sided adhesive tape will
be weakened. Wash and
degrease the surface of the
adhesion area before applying
the double-sided adhesive tape.
Be sure to wash interior and
exterior parts using IPA
(isopropyl alcohol).
Be careful when handling drills
and other sharp objects.
If not handled properly, it could
result in serious injury.
Secure the wiring harness with
the tape (part included) so that
they are not left dangling.
Otherwise, a fire or other
accident may occur due to a
short circuit.
When the negative battery cable
is removed, the initial value or
memory for the power windows,
clock, i-stop, steering
sensor reference point will be
cleared. Perform re-initialization.
If tape or a mount base is
removed and then re-adhered,
the adhesive strength will be
weakened. Before adhering,
accurately determine the
adhesion position.
4
☆Socket wrench
☆Nipper
☆Drill (1.5mm,3mm)
☆Remover tool
☆Masking tape
☆Mat
Do not pull a wiring harness with
excessive force. Doing so can
cause breakage which could
result in a short circuit or a fire.
Put the removed parts and the
kit accessory parts on a
protective sheet to prevent
angle scratches.
To assure sufficient
adhesiveness of the
double-sided adhesive tape,
press the adhesive surface of
the tape to the adhesion surface
evenly.
In particular, press sufficiently at
the ends of the double-sided
adhesive tape where the
adhesion surface is curved.