Harness Installation - Mazda C860 V7 281A Installation Instructions Manual

■ Harness installation

Cut
Strip insulation
Cushioning
Electro taps
tape
Harness connector
Vehicle front
RBCM
Main harness
Vehicle front
Main harness
Wrap with electrical vinyl tape
RBCM
Cushioning tape
1. Cut the main harness (Red wire) at the position
shown in the
figure.
2. Strip the main harness insulation and wrap
electrical vinyl tape around the tip of the stripped
main harness for insulation.
CAUTION
 Always insulate the main harness.
3. Connect the wiring harness included in the optional
on/off switch kit to the main harness stripped in
Step 1. with electro taps. (No polarity)
CAUTION
 For branch connection procedure using electro
tap, refer to [Branch connection procedure using
electro tap (Optional ON-OFF switch installed)]
on page 5.
4. Wrap the electro taps in the 2 locations and the
harness connector with cushioning tapes.
38