Skil PWRCORE 12 DL529001 Owner's Manual page 14

Torque-Adjustment Ring
Your tool features 17+1 clutch settings. Output
torque will increase as the torque-adjustment
ring is rotated from 1 to 17. The drill "
position will lock the clutch to permit drilling
and driving for heavy-duty work (Fig.6).
When using the drill/driver for different driving
applications, increase or decrease the torque in
order to help prevent damaging screw heads,
threads, workpiece, etc.
The proper setting depends on the job and the
type of bit, fastener, and material you will be
using. In general, use greater torque for larger
screws. If the torque is too high, the screws
may be damaged or broken. For delicate
operations, such as removing a partially
stripped screw, use a low torque setting. For
operations such as drilling into hardwood, use a higher torque setting.
NOTICE: Do not adjust the torque when the tool is running.
LED Worklight
Your tool is equipped with LED worklight,
located on the base of the tool, which
illuminates when the variable-speed trigger
switch is squeezed. This provides additional
light on the surface of the workpiece for
operation in lower-light areas (Fig.7).
The LED worklight will automatically turn on
with a slight squeeze on the trigger switch
before the tool starts running, and will turn off 8
to 12 seconds after the trigger is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED worklight will rapidly
flash. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool.
The LED worklight will flash more slowly to indicate that the battery pack is at low-battery
capacity. Recharge the battery pack.
14
Fig. 6
"
Torque Indicator
Fig. 7
LED Worklight
Torque-Adjustment Ring
Torque Settings