Table of Contents
Advertisement
M-Link C connection
C
C
C203 or
Ouflex C
Ouflex M or
RJ45 connector
Ouflex M BA
S203 or
RJ45-I connector
H23
Modbus RTU bus
B A
Modbus TCP/IP bus
C
C
These connections are only used with Ouman' s own devices fitted with an RJ45
connector. The C connections are identical. You can connect M-Link-compatible
Ouman device in one connector and a GSM modem (GSMMOD) in the other for
text message communication (C203 and S203 only). When connecting an Ouman
device to a C connector, make sure that Access is on (System settings ->Network
settings -> Access "On"). For further information, see p. 4.
Features
RJ45
•
Connecting an Ouman device to M-Link interfaces, importing network features
connector
•
Conversion of the registers to Modbus RTU and TCP/IP buses
•
The platform version of a connected Ouman device can be remotely updated
•
Downloading applications via an LAN / remote connection
•
Process monitoring of devices with a Ouflex C platform
•
The power supply of an M-Link device comes from an Ouman device con-
nected in the C connector
Supported Ouman devices:
•
C203 v.1.5.1 (the older versions must be updated to obtain M-Link support)
•
Ouflex C (Platform v. 4.0.0 ->)
•
Ouflex M (Platform v.1.2.0->)
•
Ouflex M BA (Platform v.1.0.0->)
•
S203 (v. 1.2.0 ->)
Older Ouman devices, such as EH-203 and EH-105, as well as third-party devices,
can be connected via this connection.
Features
•
Connecting a device to M-Link interfaces
•
Resetting the alarm registers of EH-203 and EH-105 devices via Ounet
Supported devices
•
All Ouman devices with MB-RTU support
•
All third-party devices with MB-RTU support
The devices can communicate with the MB TCP/IP network via this connection (the
general network cabling can be utilised).
Features
•
Connecting a device to M-Link interfaces
Supported devices
•
All Ouman devices with MB-TCP/IP support
•
All third-party devices with MB-TCP/IP support
2
Advertisement
Table of Contents
