Table of Contents
Advertisement
Update
Setting
Device (M-Link)
Firmware update
Application update
Reboot device
Restore default
Controller
Firmware update
Application update
Reboot controller
Restore default
Change password
Current password
New password
Confirm password
Change
In the Update tab, you can perform updates of the M-Link device and
the device connected to M-Link' s C connector and restore factory
settings. The password can also be changed in the Update tab.
The devices can also be updated using the Ouflex BA Tool.
Remote update of the controller using the OuflexTool
Make the following selections:
Select the address ->
The tool allows specifying whether the firmware is also updated in
conjunction with the application update. The selection is made at
"System settings" ->
files/ Device firmware file. If you select "True", the firmware is updated
in conjunction with the application update.
Description
Updating the firmware of M-Link device. An img file is downloaded to the device
Update of M-Link' s control application: Select the compressed zip folder and then select "Upload".
The M-Link can unzip the compressed folder. Aplication can be updated also online using the Ouflex-
Tool tool.
Rebooting of the M-Link device
Restore factory settings.
This is a controller connected to the C connector of the M-Link device.
Remote update of the controller requires that the controller has a memory card in place and the
controller platform is v. 1.2.3 or later. H23 controllers have memory card readers starting from version
2.0.0 which is why older H23 devices cannot be remotely updated via M-Link.
The devices with an Ouflex C platform can be updated starting from version 4.1.1.
When performing the update, you can decide whether the controller settings are kept (Keep set val-
ues) or are factory settings restored (Clear set values). You can also cancel the update (Cancel updat-
ing).
You can change the password of the M-Link device. Username = service, and the password (pwd) is
shown in the label at the end of the M-Link device
Enter the current password in the "Current password" field.
Enter the new password in the "New password" field.
Re-enter the new password
The new password is activated when you click on "Change password".
5
"Connect" ->
5
6
1
Additional system settings: Downloading
14
"Run" ->
To: Online ->
1
2
6
"Load applications to device"
2
4
scan->
3
4
3
Advertisement
Table of Contents
