Table of Contents
Advertisement
Settings
Alarm routing:
The SNMP function can be used for alarm transfers between Ouman devices and the control room.
tion can be used for sending information on the activation, elimination and resetting of alarms to the desired server using the SNMP
protocol.
Setting
SNMP server IP
Retry delay
SNMP in use
From the M-link device, information about alarm can also be transmitted using the HTTP protocol.
Setting
HTTP server address
HTTP alarm in use
Please note: If Access connection is used, M-Link's Access IP address or name (m
Ounet as the local IP address.
Network
1
192.168.1.1
255.255.255.0
192.168.1.254
8.8.8.8
2
5
xx.xx.xxx.xxx
Factory setting
Description
10.1.1.23
The IP address of the destination server where the message is sent. Ounet' s
IP address 10.1.1.23 is the default.
5 min
If the alarm is not acknowledged from the server, the alarm message will be
resent after the delay that is set.
This selection enables/disables the entire SNMP function.
Factory setting
Description
The IP address of the destination server where the message is sent.
This selection activates the sending of alerts via HTTP messages.
There are two alternative ways to set the M-Link device IP address and
network settings:
1. IP address is retrieved via DHCP function.
2. IP address is set manually.
Alternative 1. Setting the IP address via DHCP function:
This requires that network has DHCP service that assigns an IP address for
M-Link
.
1.
Select "DHCP in use" .
2.
Select "Confirm".
3.
Wait approximately one minute.
4.
Select
. If the IP settings changes, the new IP settings have been successfully
received. If the IP settings do not change, make sure the connections are correct and
that the network has a DHCP server.
5.
If you select "Ouman Access in use", M-Link retrieves the Access IP address
FTP in use: With FTP enabled, you can download the template file to Ounet directly
from the device (see page 4).
Alternative 2: Setting the IP address manually:
1.
You can deactivate the function at "DHCP in use". (If the DHCP function is on, the
manual changes will be bypassed at IP address , Subnet mask, Gateway address and
Name server address).
2.
Ask the network administrator for the network settings and enter the desired settings.
3.
Select "Confirm".
xxxxxxxx
11
The SNMP func-
.ouman.net) must also be set at
Advertisement
Table of Contents
