Table of Contents
Advertisement
BEFORE STARTING THE KIT...
Before starting this kit, prepare the following tools:
●
Soldering iron
●
Multi-meter
●
Flush cutters
●
Smaller pliers
●
n2. hex screwdriver or allen key (enclosed with kit)
●
Phillips screwdriver
●
Wrench No. 8
●
Protective eyewear
●
Isopropyl alcohol + smaller and clean brush (optional)
We suggest that you work in a clean and a well lit and ventilated environment to avoid accidents or
losing any of the small components. Also briefly go through this guide and make sure that you
understand all the steps before you start soldering.
When you are done with soldering, you would probably like to calibrate your Popcorn. It is pretty
simple. Please check the info about firmware v1.1 and calibration guide
BOTTOM BOARD
RESISTORS
Start with the bottom board parts. First of all, take your time and check the v alues of all r esistors
using a multimeter
(or you can check the color codes if you are seasoned enough):
3
220R (1x), 1 k (1x), 1 0k (1x), 3 3k (1x), 4 7k (1x), 1 00k (8x), 3 30k (1x), 4 M7 (1x).
-
Then solder them on the bottom PCB and snip the leads close to the PCB (be sure to make this step
on all remaining leads in the course of this guide).
h ttp://www.bastl-instruments.com/wp-content/uploads/2018/06/popcorn-v1.1-update.pdf
2
h ttps://learn.sparkfun.com/tutorials/how-to-use-a-multimeter/measuring-resistance
3
4
2
h ere
.
Advertisement
Table of Contents
