Table of Contents
Advertisement
JACKS, POTENTIOMETERS, BUTTONS & LEDS
You are almost done. Let's do the rest of the components by just putting them in first ( n o soldering
yet! It starts at point 8! ) :
1) Unmount the top board.
2) Insert green L EDs (9x) - w atch out f or orientation ! (the longer lead has to go into the plus
(+) hole signed on PCB). Insert also the transparent ones (6x) - watch out f or orientation
again !
3) Insert b uttons (9x) - be sure they're at the right angle and right on the board.
4) Try the c enter detent potentiometers (2x) and place them at their spot - be sure they're
placed in the right angle and they're right on the board. Then do also the rest of
potentiometers (8x) .
5) Insert j ack c onnectors (6x).
6) Mount the spacer to the f ront p anel .
7) Place the f ront panel on and mount the jacks (you don't have to mount them all as you have
to unmount them in the next step).
8) Mount the spacer with the other one. Check the position of all the parts if they are flat on the
board and at the right angle, push the LEDs to the panel and do the soldering (SOLDERING
TIP: you can start by soldering just one of the leg at each component so you can make
adjustments easier by reheating)
17
Advertisement
Table of Contents
