Page 1
This product herewith complies with requirements of EMC directive 2014/30/EU. In addition it complies with RoHS directive EN50581:2012 B100-SA Standalone Biometric Reader 1 Relay Remote Unit and request-to-exit Bu on B100-SA-KIT Standalone Biometric Kit User Manual Visual Plus Corporation, s.a. Drève Richelle 161 WOP G - Bte 34 1410 Waterloo - Belgium...
“gummy” fingers. RTT is remote relay control unit for B100-SA(DINB100-SA) biometric reader. If secure installation is needed, the biometric reader can be connected to remote relay unit at secured area, which also plays the role of exit push button. It has one relay output and one exit button input.
(fi ed with addi onal heater if very low temperature) to keep a constant sensor level performance. XPR™ cannot guarantee the func onality of the product if measures and advice before are not followed.
4.0 A PPLICATION IAGRAM 11.8 Set Door Relay Time Relay1 time Relay2 time (for Relay 1 in B100-SA, RTT and DINRTT ) R 485 (max. 50m) (for Relay 2 in DINRTT Remote Relay Unit) Swipe the Master/Admin Swipe the Master/Admin finger 9 mes...
11.0 B100-SA P ROGRAMMING 6.0 R ECOMMENDED WIPING ECHNIQUE 11.7 Se ngs Follow the below instructions for correct finger swiping 11.7.2 Buzzer Sound and Remote Relay Touch Func on Starting from the first finger joint, place the selected finger on the swipe sensor and move it evenly towards oneself in one steady movement.
11.0 B100-SA P ROGRAMMING 8.0 Q UICK ROGRAMMING 11.7 Se ngs 11.7.1 Entry Mode and Backlight 8.1 Adding Master Finger and delete all users Entry MODE Backlight 1.Push dip switch no.2 in position ON. No.2 2.Reset the Power of the device. 3.Wait for One long + mul ple short beeps 4.Put the dip switch in position OFF.
11.0 B100-SA P ROGRAMMING 8.2 Add User In Group 1 11.7 Se ngs Master Finger x 1 1. Swipe the Master or Admin Finger Figure.1 2. Swipe the user finger min. 6 mes (un l Ok Beep) Swipe the Master/Admin finger 10 mes un l User Finger x 6...
B100-SA OK Beep 1. Put Dipswitch No.1 to posi on ON. RTT beeps con nuously and the red led blinks. 2. Put Dipswitch No.1 to posi on OFF. 3. Wait for Beep + OK Beep (short + short + long beep) A er the OK beep, the coupling is done.
11.0 B100-SA P ROGRAMMING 11.0 B100-SA P ROGRAMMING 11.5 Add Administrator 11.1 Adding Users Swipe the Master/Admin finger 5 mes un l the light pa ern on figure.9 is shown Swipe the Master/Admin finger 12 mes un l the light pa ern on figure.10 is shown Figure.9 Figure.10 x 12...
11.0 B100-SA P ROGRAMMING 11.0 B100-SA P ROGRAMMING 11.4 Delete Group of Users 11.2 Delete User Swipe the Master/Admin finger 7 mes un l the light pa ern on figure.12 is shown Swipe the Master/Admin finger 6 mes un l the light pa ern on figure.13 is shown Figure.12 Figure.13...