Multiprotocol keypad with integrated proximity reader (12 pages)
Summary of Contents for xpr B100PROX-MF-SA
Page 1
B100PROX-MF-SA 11.9 Set Door Relay Time Standalone Biometric Mifare Reader Relay1 time Relay2 time (for Relay 1 in B100PROX-MF-SA,RU2, RTT and DINRTT ) (for Relay 2 in R 2 U , DINRTT Remote Relay Unit) Swipe the Master/Admin Swipe the Master/Admin USER’S MANUAL...
8.7 Quick Programming in “Finger ON Card” Mode ......Reader OFF AIRING IOMETRIC R DER AND EMOTE ELAY NIT Reader OFF ........... Pairing B100PROX-MF-SA with DINRTT All ON ............All ON Pairing B100PROX-MF-SA with RTT ............10.0 K EEP THE OOR NLOCK...
MENU sealed wall mount box (fitted with additional heater if very low temperature) to keep a constant sensor level performance. XPR™ cannot guarantee the functionality of the product if measures and advice before are not followed. Example: It is also strongly recommended to use double technology biometric readers when use outdoor to offer first higher Task: Set the Reader to work in “Finger and Card”...
B (RS485) Violet Gray Grey Yellow Relay Figure.11 x 13 Yellow (2A) White White Tap sensor Wiring B100PROX-MF-SA with magnetic lock 12VDC POWER SUPPLY Black Pink Select Admin nr. GND (PB) Violet Blue Scroll down to select: Green Orange Gray...
6.0 R ECOMMENDED WIPING ECHNIQUE 11.0 B100PROX-MF-SA P ROGRAMMING 11.6 Add Administrator Follow the below instructions for correct finger swiping Starting from the first finger joint, place the selected finger on the swipe sensor and move it evenly towards oneself in one steady movement.
8.0 Q UICK ROGRAMMING 11.0 B100PROX-MF-SA P ROGRAMMING 11.5 Delete Group of Users 8.1 Adding Master Finger and delete all users Swipe the Master/Admin finger 6 mes un l the light pa ern on figure.13 is shown Figure.13 1.Push dip switch no.2 in position ON.
With this, the quick programming is completed. The system is now operational with default value for Door Open Time of 3 seconds. Tap sensor to confirm or For more comprehensive programming, refer to the “B100PROX-MF-SA Programming” section. swipe UP to Cance Important: When using proximity reader for Finger Or/And Card Mode, first present the Card then swipe the finger min.
11.0 B100PROX-MF-SA P ROGRAMMING 8.7 Quick Programming in “Finger ON Card” Mode 11.2 Adding Users in Finger ON Card Mode Important Note: Before enrolling in “Finger ON Card” mode, put the Reader in “Finger ON Card” mode. Swipe the Master/Admin finger...
Swipe the Master/Admin finger 5 mes un l devices or refer to the Remote Relay’s Manual. the light pa ern on figure.9 is shown 9.1 Pairing B100PROX-MF-SA with DINRTT Figure.9 12 VDC DINRTT 1. Close the Jumper. DINRTT beeps continuously and the red led blinks.