Contents 1. DESCRIPTION 2. SPECIFICATIONS 3. MOUNTING 4. WIRING 5. CONNECTING BIOMETRIC READERS TO EWS CONTROLLER 5.1 CONNECTING BIOMETRIC READERS IN SAME RS485 LINE WITH THE EWS CONTROLLERS 5.2 CONNECTING BIOMETRIC READERS WHEN ALL THE CONTROLLERS HAVE TCP/IP COMMUNICATION 6. CONNECTING BIOMETRIC READERS TO 3RD PARTY CONTROLLER 6.1 CONVERTERS PIN DESCRIPTION 7.
Do not install the device in a place subject to direct sun light without protective cover. BIOPROX-MF is a Wiegand biometric and proximity reader for access control applications with programmable Do not install the device and cabling close to a source of strong electro-magnetic fields like radio-transmitting antenna.
E A A A A A A A A B B B B B B B B B B B B B B B B O heater if very low temperature) to keep a constant sensor level performance. XPR™ cannot guarantee the functionality of the product if measures and advice before are not followed.
Use mouse click to select the combination you need or use right-click to check or clear entire row or column 4. WIRING 12V DC 12V DC 9-14V DC Black ground Pink RS485 A RS485 Violet RS485 B Orange LED Red - Red LED - Green LED Green -...
5.1 CONNECTING BIOMETRIC READERS IN SAME RS485 LINE WITH THE EWS CONTROLLERS 9.10 DELETE FINGERPRINTS After the transfer, the fingerprint are stored in the Biometric reader and in the PC. Jumper for RS485 termination Deleting can be done only in the software, only in the readers or from the both places. 9.10.1 Deleting one user from the biometric reader Select the users checkbox.
9.7 DELETE USERS 6. CONNECTING BIOMETRIC READERS TO THIRD PARTY CONTROLLERS Check the users to be deleted Right-click on the users table Click on Delete checked users menu 3rd party controller 3rd party controller Confirm warning message - + D0 D1 - + D0 D1 - + D0 D1...
It is recommended to do sensor calibration once after reader is mounted. Clean the fingerprint sensor before calibration. 3. In the Basic tab, for “Type” of the Reader select “BIOPROX-MF”. (8.2) 4. After selecting the type, a third tab will appear “Biometric”. Go to that tab and put the serial number of the Biometric Reader.
If reader is online, new line is added on top of the event table 8.2 ENROLLING FINGERPRINTS FROM A READER 1. Open the Users Window and create a new user. Click on “New User”, put a name, ID(card number). (8.7) 2.
Plug the Desktop Reader (BIOE) in the PC. If the device is not installed automatically use the drivers located on BioManager is software for fingerprint management of XPR Biometric readers, when used with third party the CD provided with the Biometric reader. It is installed in the same way as a USB Device. When the desktop access controllers.
8.4 DELETING FINGERPRINTS In General, the fingerprints are stored in the Biometric reader and in the Software. 8.8 SEND CONFIGURATION Deleting can be done only in the readers or from both places. · Right-click on the reader and select the Send Deleting one user from the biometric reader configuration menu Select the User...
(8.18) Select “Properties” On the Firmware update window, click on the For “type” of the reader select “BIOPROX-MF FOC” (8.30) Browse button (8.19). The default location of the firmware files installed with PROS CS is in the Writing Template on the card folder "Firmware".