Attaching The Motor Head; Cleaning - Fakir nilco S 20 E Operating Instructions Manual

Attaching the motor head

11

Cleaning

● Place the motor on the front part [11] of the canister and
press on until it snaps into place [12].
12
Please note: When vacuuming extreme fine dust, air per-
meability of the filter will be restricted considerably.
Consquence: low suction power, the filter has to be
cleaned or replaced.
Cleaning of motor protection- and permanent fine dust
filter
Please use warm water (max. 40°C) with a mild soap so-
lution or a washing-up liquid, etc.
The filter has to be dry before using it again.
Switch off and unplug the vacuum cleaner be-
fore cleaning. This will prevent the appliance
from accidentally being switched on.
Do not use cleaning agents, abrasives or alco-
hol, since they could damage the housing.
Clean the appliance only with a dry or moist cloth. You can
also clean the filter compartment (inside the canister) with a
moist cloth, if required.
Check the accessories, such as the hose, tubes and nozzles,
regularly for blockage and clean; wash out, if necessary, and
let dry.
In the event that the appliance does not perform satisfactorily
(reduced suction power, unusual noises or failure), first
check whether the filters are blocked or dirty or whether there
is blockage in the hose or tubes.
After use
WARNING!
ATTENTION!
en
17