Installation And Connections; Electricity; Plumbing; Chimney Connection - Teba therm TP-12 Installation & Manuals

3.0 Installation and Connection
Product assembly and plumbing connection must be installed also by authorized person.
Pellet stove is a full automatic device. Expansion tank, circulation pump, thermostat, safety valve,
switch, sensor and similar parts are located inside the stove safely.
3.1.

Electricity

Electricity system should be 220V-230V/50Hz. Our company is not responsible for any problem which
occur in case sudden low or high volt.
Note: Keep plug of device on outlet during summer-winter. Protection freezing Works under +8 °C.
It makes pump work 15-20 seconds for per 24 hours automatically to avoid lock pump.
3.2.

Plumbing

Technically, stove radiator plumbing connections should be made by an expert or qualified person to
guarantee a correct operation. Our company is not responsible for any mistakes that will occur while
installing and assemblying
After taking all safety measures, main line pipes can be connected until last a few radiators with
1"pipe(PVC or metal) without more elbow. Thus hot water can circulate easily, and so you feel heat in
the shortest time. Later ¾ pipes(PVC or metal)can be used.
Plumbing main line pipes should be connected to radiators safely with connection apparatus like
assembly diagram.(record, valve, nipple). After connection, water is added with help of valve from
point that is determined by expert. And later tightness must be controlled and taken air on radiators
and valves.
You should put antifreeze on plumbing against freezing and corrosion, according to climate
conditions.
3.3.

Chimney Connection

We advice steel chimney pipe for chimney connections. Pellet stove can be connected to multiple
chimney. Chimney can be given outside directly according to place of stove. Or can be connected
available chimney in short distance.
9