General Information; Safety; Safety Distances(Minimum Distance) - Teba therm TP-12 Installation & Manuals

2.0 General Informations
All required standart examinations have been made for your product. Predicted parameters
associated with combustion efficiency and exhaust gas emissions are observed. The conformity of the
product described in this manual was tested in IMQ Primacontrol Laboratory
Pellet stoves provide comfortable and easy use through heating radiators, blowing hot air to ambient
and fireplace view.
Pellet stove is a full automatic device. Expansion tank, circulation pump, thermostat, safety valve,
switch, sensor and similar parts are located inside the stove safely.
Pellet stove provides to ignition through resistance, loading fuel through auger and reductor, also
blowing and emission of chimney through fans.

2.1 Safety

Product assembly and plumbing connection must be installed also by authorized person.
Before installing stove, lifting capacity of the installation ground should be checked whether it is
resistant for stove. In case of low resistance or low lifting capacity, suitable precautions must be
taken.(for example a stove lifting plate must be put) If the floor stove installed is flammable or heat-
sensitive, you should place the product on a protection plate floor (marble or glass substrate).
You should care about air condition for the area stove is installed and take measures against freezing
The stove can be used with multiple chimney system.
Chimney can be given outside directly according to place of stove. Or can be connected to available
chimney in short distance.
Our company is not responsible for the problems that can occur because of this.
Prefer quality pellet to obtain heat efficiency and to make life of device long. Don't use wet or moist
pellet, shavings, wood or coal...etc.
Pellet stove shouldn't be installed in an area like bathroom, cellar, coal-hole since the stove designed
for indoors.
Attention! Before using stove and radiators please control water level.
*** Stove should not be used without water.***
Our company is not responsible for the problems that can occur because of this.

2.2 Safety Distances(minimum distance)

While installing the stove, fire regulations and chimney's instructions must be complied. For any
related questions please ask chimney provider. Flammable or heat-sensitive materials (furniture,
wallpaper, wood paneling) minimum distances must be complied with (see diagram below):
6