Ac Line Fusing; Trimpot Adjustments - Baldor Series 5 Inverter IP-65 Installation And Operating Manual

TABLE 4 – FAULT RECOVERY & RESETTING THE CONTROL*
Fault
with Start/Stop Switch Installed
WARNING! The motor will automatically start when the AC line is applied or a
fault is cleared, if Jumper J4 is set to the "AUTO" or "MAN" position and the
Start/Stop Switch is eliminated.
VII. AC LINE FUSING
VIII. TRIMPOT ADJUSTMENTS
WARNING! If possible, do not adjust trimpots with
the main power applied. If adjustments are made
with the main power applied, an insulated adjustment tool
must be used and safety glasses must be worn. High volt-
age exists in this control.
result if caution is not exercised. Safety Warning, on page 1,
must be read before proceeding.
A. Maximum Speed (MAX):
B. Minimum Speed (MIN):
C. Acceleration (ACCEL):
Note:
D. Deceleration (DECEL):
Auto Mode
Fire and/or electrocution can
Manual Mode
with Start/Stop Switch Installed
Auto or Manual Mode
with Start/stop Switch Removed
Do not fuse motor leads.
FIGURE 17
MAX TRIMPOT RANGE
FIGURE 18
MIN TRIMPOT RANGE
30
15
0
Percent of Frequency Setting
(Shown Factory Set to 0%)
FIGURE 19
ACCEL TRIMPOT RANGE
35
40