Sharp MX-3070N Handy Manual page 58

Hide thumbs Also See for MX-3070N:
Table of Contents

Advertisement

TEST SIMULATION
66
Fax Control Settings & Adjustments
01 Fax Soft SW setting
SW24
Communication Signal sending level
(bits 1-8):
Default Value (Australia/NZ)
00001011
SW27-4
V.34 mode function (call arrival):
0 = V.34 valid.
1 = V.34 invalid.
SW27-5
V.34 mode function (polling when
calling):
0 = V.34 valid.
1 = V.34 invalid.
SW27-6
V.34 mode function (manual
communication):
0 = V.34 valid.
1 = V.34 invalid.
SW33-6,
Transmission cable amplitude
SW33-7;
equaliser:
00 = 0dB
01 = 4dB
10 = 8dB
11 = 12dB
02 Country code default set (Fax)
03 Fax PWB (modem) controller memory check
04 Fax signal line check (Max level)
05 Fax signal line check (Soft SW setting level)
06 Fax list print (confidential registration)
07 Fax image memory printout (all data)
08 Fax sound message setup
09 Fax signal line check (Soft SW setting)
10 Fax & Image data all memory clear
11 Voice signal check (line/speaker 300bps)
12 Voice signal check (line/speaker 300bps)
13 Register dial number for Sim 66-14/15/16
14 Adjust/check the time dial pulse (10bps)
15 Adjust/check the time dial pulse (20bps)
16 Adjust/check the send level DTFM signal
17 DTFM signal to send to line (Max level)
18 DTFM signal to send to line (Soft SW level)
21 Print various registration information
22 Set the sound volume of the handset (Japan)
29 Fax address book clear
30 Tel/LIU sensor status check
31 ON/OFF setting of output port (Tel/LIU)
32 Received data check (comparison)
33 Busy Tone/CNG/CED/FNET detect check
36 Check Send/Receive from modem.
39 Check Destination saved in Fax EEPROM
42 Rewrite PIC program installed on Fax box
58
66
Fax Control Settings & Adjustments
43 Write program & adjustment values to PIC
installed on Fax
61 Display FAX related soft switch (151-250)
62 FAX receive data export in PDF format.
67
Printer Settings & Adjustments
17 Printer NVRAM clear
24 Printer colour balance auto adjustment
25 Printer colour balance manual adjustment
26 Set the target colour balance for printer
mode auto colour adjustment
27 Set the target colour balance for printer
mode auto colour adjustment (Service)
28 Set the printer mode auto colour adjustment
back to factory default (Service)
31 Printer calibration data clear
33 Printer screen gamma adjust. (PCL/PS)
34 Printer maximum density adjustment mode
36 Adjust the density in printer low density
areas
41 2 colour print setup
42 2 colour print density setup
43 2 colour mode colour balance adjustment for
printer
52 Printer default gamma check (PCL/PS)
54 Printer colour balance adjustment
SHARP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx-3570nMx-4070n

Table of Contents