Update Process - Total Phase Advanced Cable Tester User Manual

phone, tablet, or most often a PC. Please consult the Quick Start Guide at the end of this
manual or on our website at Quick Start Guide (http://www.totalphase.com/support/
articles/235050988).

3.3 Update Process

In order to update your Promira databases properly, you must follow the below procedure
to backup any custom profiles you have created, reset the profile database, and then
restore any custom profiles.
The full update sequence is:
1. Start the Promira Utility (v1.35 or later available at Download) and use it put the
Promira in firmware update mode:
a. Click the Promira button.
b. Find your Promira device in the list. If it doesnt appear yet, wait a little while
for it to finish booting and enumerating, then click the button to refresh the
list.
c. Select the Promira which was found, and click OK.
d. Click the Update License/Firmware button.
2. Copy the new firmware (.pmu file) to the Promiras disk. Typically your PC will
notify you that a new disk has been detected, and give you the option to browse it.
You may need to manually navigate to it using Finder or Explorer.
3. Eject the USB disk
4. Power-cycle the Promira the firmware will be automatically updated, which will
take about a minute to complete, during which time the LEDs will blink blue.
5. Wait for the right-most LED to illuminate green, then login to the Advanced Cable
Tester.
6. Open the "Profile Management" screen.
Advanced Cable Tester User Manual v1.13.001
9