Starting Pc Mode - Samsung digimax U-CA 501 User Manual

Starting PC Mode

If you connect the USB cable to a USB port on your PC and then turn on the power, the
camera will automatically switch to "computer connection mode".
In this mode, you can download stored images to your PC through the USB cable.
The LCD monitor is always turned off in PC mode.
The camera status lamp will blinks when the files are transferring via the USB connection.
Connecting the camera to a PC
1. Turn the PC power on.
2. Turn the camera power on.
3. In any mode other than Voice Recording mode, press
the MENU button.
4. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
5. Select the [USB] menu by pressing the UP/ DOWN
button and press the RIGHT button.
6. Use the UP and DOWN buttons to select
[COMPUTER], and then press the OK button.
7. Press the menu button twice and the menu will disappear.
8. Connect the PC and the camera via the USB cable.
- Insert the small plug of the USB cable into the camera USB connection terminal.
- Insert the large connector of the USB cable into the USB port of the PC.
- The plugs must be firmly inserted.
If you selected [PRINTER] in Step 6, when
you connect the camera to your computer,
the [CONNECTING...] message will be
displayed on the LCD monitor and the
connection will not be established. In this
case, disconnect the USB cable, and then
follow the procedure from Step 3 and
onward.
Disconnecting the camera and PC : Refer to page 103 (Removing the removable disk).
INFORMATION
The camera driver must be installed before using PC mode.
When you connect the camera to a computer, you have to use the USB cable supplied
with the camera, or the computer can't recognize the camera.
98
2048
SETUP
IMPRINT
COMPUTER
SOUND
USB PRINTER
SET:OK
BACK: