E-Z-GO 2Five Electric Service Manual page 27

Read all of Section A and this section before working on vehicle. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
ATTACH NEGATIVE WIRE
FROM ACCESSORY TO
(-) BATTERY TERMINAL
ATTACH POWER WIRE
FROM ACCESSORY TO
(+) BATTERY TERMINAL
Fig. 1 Attach Accessory Wires to Battery Pack
Accessories connected to this vehicle that do not use
the accessory harness must be connected across the
entire 48 volt battery pack. This can be done by con-
necting to the two battery terminals shown in Figure 1.
This can be done by connecting to the two battery termi-
nals shown in the illustration.(Ref. Fig. 1) If the acces-
sory requires voltage other than 48 volts it must be
connected to the DC to DC converter to change the volt-
age to the amount required by the accessory. A DC to
DC converter is supplied as part of the on-board battery
charger on this vehicle.
Repair and Service Manual
B
SAFETY
B
Page B-3