Advertisement
Make Your First Latte
MAX
1
2
Place Mug & Pod
Fill Frother
Place a mug on the drip tray. Lift the handle
Remove lid and add chilled milk to the MAX line
and place any K-Cup® pod in the K-Cup® pod
marked in the frother. Replace the lid and place
holder. Lower the handle completely to close the
the frother on the frother base.
lid.
Press the power button on the frother.
Do not remove the foil lid on the K-Cup® pod.
The button will illuminate while heating –
approximately 3 minutes. Frothing is complete
when the button flashes and then turns off.
CAUTION: Frother is not microwave or dishwasher safe.
NOTE: Do not under or overfill frother. Do not operate before adding milk.
Brewer Features
Caring for your Brewer
Frother froths milk to create your favorite latte.
Regular cleaning keeps your brewer running smoothly.
Always be sure to turn off and unplug your brewer
SHOT button brews a shot of coffee to make
before cleaning. For detailed brewer cleaning and
delicious, creamy lattes.
maintenance instructions, videos, and the full Use &
Smart Start heats then brews in one simple
Care guide, visit support.keurig.com. Beyond these
process. No need to wait for the brewer to heat
recommended cleaning instructions, this brewer is not
before selecting brew size. Power on your brewer,
user-serviceable. For service, please refer to the
place mug, insert a K-Cup® pod, and lower the
Warranty included with your brewer.
handle. Then, select your brew size. The brewer
will heat, then automatically begin brewing.
Frother
Auto Off automatically turns your brewer off
Clean immediately after each use and before first use.
2 hours after the last brew for energy savings.
To Clean:
1. Remove frother from the base, remove silicone ring
from lid, and remove the whisk from inside the frother.
2. Wash the silicone ring, lid, and whisk with warm,
soapy water.
3. Clean the interior of the frother with soap and rinse
with warm water. Use a soft, non-abrasive cloth or
sponge to prevent damaging the inner coating.
4. Wipe the exterior with a soft, damp cloth.
5. Dry all parts thoroughly and reassemble for next
use.
Note: Frother is not dishwasher safe. Do not submerge frother in water. Only use
non-abrasive cleaning materials to prevent damage to the inner surface of the
frother.
Add Water
10
oz
oz
8
6
oz
SHOT
LATTE
Add Water
10
oz
8
oz
6
oz
SHOT
LATTE
3
Brew a Shot
The three brew buttons and SHOT button
will blink. Press the SHOT button. Brewing is
complete when the SHOT button is no longer
illuminated.
NOTE: After 60 seconds, the brew buttons will be disabled. To
re-activate, lift and lower the handle completely.
CAUTION: While brewing, there is extremely hot water in the
pod holder. To avoid injury, do not lift the handle during the brewing
process.
Water Reservoir
The water reservoir lid and water reservoir should
be cleaned periodically. Clean in a dishwasher
(top rack only) or hand wash. To hand wash, use
a damp, soapy, non-abrasive cloth. Rinse the
reservoir thoroughly after cleaning. This will
ensure that no cleaning solutions remain in the
area as they may contaminate the water supply.
After rinsing, fill the reservoir with clean water
and return it to the brewer. Do not dry the inside
of the water reservoir with a cloth as lint may
remain.
Exit Needle
Remove the pod holder
assembly and detach the
funnel. Locate the exit needle
on the inside bottom of the
K-Cup® pod holder. Insert a
straightened paper clip into the
exit needle to loosen any coffee
grounds.
4
4
Create your Latte
Remove the frother from the base. Remove the
lid and pour the frothed milk over your shot of
coffee.
NOTE: Clean frother immediately after use. For cleaning instructions,
see Caring for your Brewer section in this guide.
K-Cup®
Entrance Needle
Lift the brewer handle and locate the entrance
needle on the underside of the lid. To clean both holes
in the needle, hold the brewer handle in the upward
position and with your other hand, carefully insert a
straightened paper clip into both holes. Gently move
it around to loosen any coffee grounds. Lower the
handle completely and run two water-only brew
cycles. Do not insert a K-Cup® pod.
CAUTION: There are sharp needles that puncture
the K-Cup® pod above the K-Cup® pod holder and
in the bottom of the K-Cup® pod holder. To avoid
risk of injury, do not put your fingers in the K-Cup®
pod holder.
Brew Your First Coffee
Add Water
10
oz
8
oz
6
oz
LATTE
SHOT
2
1
Place Mug & Pod
Brew & Enjoy!
Place a mug on the drip tray plate. If using a
Select your brew size. The button will remain
travel mug, remove the drip tray and place the
illuminated while brewing – about 1 minute.
mug on the drip tray base. Lift the handle and
Brewing is complete when the button is no longer
place a K-Cup® pod in the K-Cup® pod holder.
illuminated. Lift the handle and dispose of the
Lower the handle completely to close the lid.
used K-Cup® pod.
Do not remove the foil lid on the K-Cup® pod.
The brewer will be ready to brew another cup in
about a minute.
High Altitude Brewing: While holding the brewer
handle up, push down slowly on the K-Cup® pod
NOTE: After 60 seconds, the brew buttons will be disabled. To re-activate,
lift and lower the handle completely.
in the pod holder until the bottom of the K-Cup®
pod is punctured by the exit needle.
CAUTION: While brewing, there is extremely hot water in the K-Cup® pod
holder. To avoid injury, do not lift the handle during the brewing process.
Coffeehouse taste in your own home.
FIND YOUR PERFECT POD
With over 70 brands and hundreds
of varieties, find your match at
keurig.com/new
Have questions? We're here to help. Visit keurig.com/new for troubleshooting
videos, maintenance recommendations, and the full Use & Care Guide.
Still need help? Give us a call at 1-866-901-BREW (2739)
Add Water
10
oz
oz
8
oz
6
SHOT
LATTE
Add Water
10
oz
8
oz
6
oz
SHOT
LATTE
DC0000001292 REV B
Advertisement
