Figure 33. Removing the internal speakers
Figure 34. Installing the internal speakers
7. Route the new internal speaker cable, and then connect the cable to the system board.
8. Reinstall the removed parts. To complete the replacement, see "Completing the parts replacement" on
page 47.
Replacing the serial connector and parallel connector module
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove the computer stand. See "Replacing the computer stand" on page 14.
2. Remove the computer cover. See "Removing the computer cover" on page 16.
3. Remove the system board shield. See "Replacing the system board shield" on page 20.
4. Disconnect the serial connector cable and the parallel connector cable from the system board.
5. Replace the serial connector and parallel connector module.
.
Chapter 4
Replacing hardware
25