Yetter 6300 Operator's Manual page 6

ASSEMBLY INSTRUCTIONS
Hanger Bar
STEP 1. Attach the hanger bar assembly to the 8" x 8" center frame using the 4) 1" x 11" hex bolts and 1" hex lock
nuts. The right rear bolt is also used to attach the toolbar depth indicator 6300-347. Position the assembly on the
center frame with 6300-212 toolbar flange plate w.a. hook over the drawbar flange plate. Torque the 1" bolts to 670
ft. lbs.
STEP 2. Attach the toolbar depth gauge to the rear of the toolbar using 1) ¾" x 5" x 6-1/2" u-bolt, 6300-348 strap,
and ¾" lock nuts. Locate the depth gauge up to the right hand side of the center frame.
6