Yetter 6300 Operator's Manual page 15

Optional Toolbar Gauge Wheels
STEP 1. Attach the gauge wheel bracket near the end of the front toolbar using 2) ¾" x 5" x 6 ½" u-bolts and ¾" lock
nuts. Mount the bracket with the depth indicator to the inside of the cart.
STEP 2. Mount the jack assembly to the gauge wheel bracket by installing the jack from the front. The decal strap
needs to be between the depth indicator and the bracket. Secure the jack assembly with 2) ½" x 4" eyebolts, 2) ½" x
4" hex bolts and ½" hex lock nuts. DO NOT OVER TIGHTEN.
STEP 3. Mount the tire/rim assembly to the hub using 4)
bolts. The recommended torque on these bolts is 85-95 ft.
STEP 4. Check clearance of tire and the gauge wheel
slide the jack assembly as necessary to ensure clearance.
ASSEMBLY INSTRUCTIONS
½" wheel
lbs.
bracket;
15