Troubleshooting - Pool Controls Chemigem D10 User Manual

Trouble-shooting
Before requesting service, you may wish to run through the check list below but feel free
to call Pool Controls Service on 1300 550 010 or log a service call via our website –
www.poolcontrols.com.au.
If there appears to be low or no Chlorine Residual:
1. Check stabiliser level is 40ppm – 60ppm. Add if necessary and wait for it to dissolve.
2. Have you added any chemical additives recently?
3. Check pool for phosphates and remove if necessary
4. Is the unit turned on and operating the filter pump?
5. If the unit is not running at all, check the fuse in the bottom of the unit.
Operation Following a Power Failure
®
The ChemiGem unit comes with a timer function built into the operating software. The
timer is a 24-hour type with quartz-crystal control. This Timer is backed-up by a Real-Time
Clock (RTC) similar to those found in computers.
During a power failure the ChemiGem
If a Filter Cycle is active when power is returned the pump will be turned ON within 1
minute. The ChemiGem
®
The ChemiGem is ideal for use in systems where repeated power cuts occur, such as off-
peak power circuits and Queensland's Tarriff33 system.
®
will keep time and maintain AutoMode functions.
®
will keep all its settings and will not need to be re-programmed.
Page
25