Clips
Actuator Cable
Handset Cable
Battery Cable
Remove Cables:
1.
Remove the cable lock. This may require a small screwdriver to undo the clips on the
control box.
2. Pull the desired cable out of the control box. The power cable has a clip that may require a
screwdriver to release.
Install Cables:
1.
Insert each cable into the port shown above. Some of the connectors have a guide pin for
alignment.
2. Install the cable clamp over the cables and make sure all three clips have locked in place.
This prevents the cables from being pulled out accidentally.
POWER CONNECTIONS
Guide Pin Slot
Cable Lock
Power Cable
(14)
Control
Box
2 extra fuses in here
Clip
OM00PWR Power Recliner Manual REV 1 010118