Maintenance - Mira Crescent Installation, Operation, Maintenance Manual

General
1. The maintenance of this product must be carried out in accordance with
instructions given in this Manual, and must be conducted by designated, qualified
and competent personnel.
2. Mira products are precision-engineered and should give continued superior and
safe performance, provided:
- They are installed, commissioned, operated and maintained in accordance
with the recommendations stated in this Product Manual.
- Periodic attention is given as necessary to maintain the product and its
associated installation components in good functional order. Guidelines are
given below.
3. The use of main supply-line or zone strainers (recommended maximum mesh
aperture dimension is 0.5 mm) will reduce the need to remove debris at each
mixing valve point.
Warning! Many household and industrial cleaning products contain mild abrasives
and chemical concentrates, and should not be used on polished, chromed or plastic
surfaces.
Should an internal malfunction occur then this will probably require replacement of
parts.
The designed minimum service life of all cartridges used in Mira products is 5
years providing the Mira Crescent is operated with the recommended operating
conditions and within the recommended operating parameters. However, when
supply conditions and/or usage patterns do not conform to the recommended
operating parameters and/or the recommended operating conditions, the cartridge
may need to be replaced more frequently ('recommended operating conditions'
and 'recommended parameters' are defined on page 7 of this Product Manual
under the headings of 'Normal Operating Conditions' and 'Operating
Parameters').
Components are precision-made, so care must be taken while servicing to avoid
damage.
When ordering spare parts, please state product type, i.e. Mira Crescent, and identify
part name and number (refer to PARTS LIST). A Seal pack is available, containing
all the seals that may be necessary for renewal during maintenance or servicing.
Lubricant
Important! All seals are pre-lubricated. If you need to lubricate the seals, use only a
small amount of silicone-only based lubricants on this product. Do not use oil-based
or other lubricant types as these may cause rapid deterioration of seals.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk

MAINTENANCE

26