Tennant 2550 Operator's Manual

Tennant 2550 Operator's Manual

Dust control burnisher
Hide thumbs Also See for 2550:

Advertisement

2550
Dust Control Burnisher
English
EN
Operator Manual
Model Part No.:
M611373
611581
Rev. 01 (05-2006)
*611581*
www.tennantco.com
Home
Find... Go To..

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2550 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tennant 2550

  • Page 1 2550 Dust Control Burnisher English Operator Manual Model Part No.: M611373 611581 Rev. 01 (05-2006) *611581* www.tennantco.com Home Find... Go To..
  • Page 2 P.O. Box 6 5400 AA Uden- -The Netherlands europe@tennantco.com www.tennantco.com Specifications and parts are subject to change without notice. Copyright E2001, 2006 Tennant Company. All rights reserved. EC DECLARATION OF CONFORMITY FOR MACHINERY (Directive 98//37/EEC, Annex II, sub A) Model: 2550 nr.: M611373 TENNANT N.V.
  • Page 3: Table Of Contents

    ... . CIRCUIT BREAKERS ....Tennant 2550 (05- -06) Home Find... Go To..
  • Page 4: Safety Precautions

    3. When using machine: Go slow on inclines and slippery surfaces. Use care when reversing machine. Always follow safety and traffic rules. Report machine damage or faulty operation immediately. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 5: Machine Components

    Fast Speed Pad Pressure Main Power Meter Main Power Read Manual Circuit Breaker Before Operating Slow Speed Less Pad Pressure Parking Brake Pad Motor Circuit Breaker Battery More Pad Charge Meter Reverse Pressure Tennant 2550 (02- -01) Home Find... Go To..
  • Page 6: Machine Installation

    CONNECT LAST MACHINE FRONT Connect Battery Cables 6. Apply a light coating of non--metallic grease or Set Parking Brake protective spray to prevent battery corrosion. 2. Turn OFF all switches and remove key. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 7: Machine Setup

    2. Remove the plastic centerlock from pad driver by squeezing the retainer clip on the centerlock 3. Position pad centered on pad driver and replace centerlock securely. Adjusting Control Grip Height Installing Pad Tennant 2550 (05- -06) Home Find... Go To..
  • Page 8: Machine Operation

    Pad will automatically raise to the Gradually turn speed control knob to desired transport position. cleaning speed. Turn Off Pad Switch Twist Grips to Burnish FOR SAFETY: When using machine, go slow on inclines and slippery surfaces. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 9: While Operating Machine

    Explosion or fire can result. Keep sparks and open flame away. Keep battery compartment open when charging. FOR SAFETY: When servicing machine, wear Emergency Stop Switch protective gloves when handling batteries or battery cables. Avoid contact with battery acid. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 10: Machine Maintenance

    FOR SAFETY: When servicing machine, disconnect battery connections before working on machine. FOR SAFETY: When transporting machine, do not lift machine if batteries are installed. Charging Batteries Tennant 2550 (02- -01) Home Find... Go To..
  • Page 11: Daily Maintenance

    MAINTENANCE). Check Motor(s) for Carbon Brush Wear 5. Recharge batteries (See CHARGING BATTERIES). Note: Recharge batteries only after a total of 30 minutes of use or more. This will prolong battery life. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 12: Battery Maintenance

    Use wire brush to clean terminals and cable connections. d. After cleaning, apply a coating of clear battery post protectant to terminals and cable connections. 4. Check for loose or worn cables. Replace if worn. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 13: Trouble Shooting

    Contact Service Center. board. Loose wire connection. Contact Service Center. Short run time. Low battery charge. Charge batteries. Defective battery cell(s). Replace battery. Batteries need maintenance. See Battery Maintenance. Faulty battery charger. Replace charger. Tennant 2550 (02- -01) Home Find... Go To..
  • Page 14: Specifications

    Variable 7--19 kg (15--40 lb) DUST CONTROL BAG Cloth Bag -- 98% @ 1.0 micron BATTERIES 3--215amp/hour, 12v deep cycle RUN TIME, CONTINUOUS Up to 2.2 hours DECIBEL RATING AT OPERATOR’S EAR, 70dB(A) INDOORS ON TILE Tennant 2550 (02- -01) Home Find... Go To..

Table of Contents