Elecom M-SN2DL Series User Manual

M-SN2DL Series
User's Manual
Thank you for purchasing the ELECOM M-SN2DL Series wireless laser mouse.
This manual describes the operating instructions and safety precautions for using the
M-SN2DL Series. Ensure that you have read this manual before using the product. After
reading this manual, store it somewhere safe for future reference.
* Except in certain cases, the M-SN2DL Series is referred to as "this product" in this manual.
Safety Precautions
Meaning of symbols
„
Failure to observe precautions may result in serious personal injury or death due to
WARNING
fire, electric shock, or other causes.
Failure to observe precautions may result in personal injury due to electric
CAUTION
shock or other causes, and may damage other equipment.
Prohibited action
Mandatory action
Situation that needs attention
Notes and reference information
Information that is handy to know
Observe these precautions carefully to avoid personal injury, damage, fire, and other problems.
WARNING
If a foreign object (water, metal chip, etc.) enters the product, immediately stop using the
product and disconnect the receiver unit from the PC, and remove the battery from the
mouse.
If you continue to use the product under these conditions, it may cause a fire or electric
shock.
If an abnormality is found with this product (emission of heat, smoke or abnormal smell
from the product), immediately stop using the product, shutdown the PC, and after
thoroughly checking that heat from the product will not cause burns, disconnect the
receiver unit from the PC, and remove the battery from the mouse.
After doing this, contact the retailer from whom you purchased the product.
Do not drop or hit this product.
If this product is damaged, immediately stop using the product and disconnect the
receiver unit from the PC, and remove the battery from the mouse.
If you continue to use the product in a damaged condition, it may cause a fire or electric
shock.
Do not attempt to disassemble, modify or repair this product by yourself, as this may
cause a fire, electric shock or product damage.
Do not put this product in fire, as the product may burst, resulting in a fire or injury.
Do not connect or disconnect the receiver unit with a wet hand, modify the receiver unit
or bend it forcibly, as this may cause a fire or electric shock.
CAUTION
Do not place this product in any of the following environments:
This product's packaging contains the items listed below. Before using
y In a car exposed to sunlight, a place exposed to direct sunlight,
the product, check that all items are present. We make every effort to
or a place that becomes hot (around a heater, etc.)
ensure that all products are packaged correctly. However, in the event
y In a moist place or a place where condensation may occur
that an item is missing or damaged, contact the retailer from whom you
In an uneven place or a place exposed to vibration
y
purchased the product.
y In a place where a magnetic field is generated (near a magnet,
etc.)
y In a dusty place
This product does not have a waterproof structure. Use and
store this product in a place where the product body will not be
splashed with water or other liquid.
Rain, water mist, juice, coffee, steam or sweat may also cause
product damage.
„
When you no longer need to use this product and the battery, be
sure to dispose of it in accordance with the local ordinances and
laws of your area.
Batteries
„
CAUTION
Use AAA alkaline batteries, AAA manganese batteries, or AAA
nickel hydride batteries with this product.
If this product will be unused for a long period of time, remove
the battery to avoid battery leakage and failure.
„ Cleaning the Mouse
If the product body becomes dirty, wipe it with a soft, dry cloth.
Use of a volatile liquid (paint thinner, benzene, alcohol, etc.) may
affect the material quality and colour of the product.
Cautions for Wireless Equipment
This product is wireless equipment using the entire range of the
2.4 GHz band and it is possible to avoid the band of mobile object
identification systems. DS-SS is used for the radio wave method. The
interference distance is 10 m.
The 2.4 GHz band is also used by medical equipment, Bluetooth, and wireless LAN
equipment conforming to the IEEE802.11b/11g standard.
Before using this product, check that there are no other "radio stations"*
y
operating nearby.
„
If electromagnetic interference occurs between this product and other "radio
y
stations", move this product to another location or stop using this product.
* Other "radio stations" refer to industrial, scientific and medical devices using the 2.4
GHz band like this product, other radio stations of this type, licensed radio station
premises for mobile object identification system that is used in factory production
 Wheel
lines, certain non-licensed low power radio stations and amateur radio stations.
WARNING
 Right button
y Do not use this product with a device that may have a serious
function or influence. There are rare cases where an external
radio wave at the same frequency or the radio wave emitted  Left button
from a mobile phone causes this product to malfunction, slow
down, or fail to operate.
Do not use this product in a hospital or other locations where  Remaining battery level indicator lamp
y
the use of radio waves is prohibited. The radio waves of
this product may affect electronic and medical devices (e.g.
pacemaker).
y The use of a wireless mouse in an aircraft is prohibited by
aviation law because doing so may interfere with flight safety.
 Power switch
Turn off the power of the mouse body before boarding an
aircraft and do not use it in the aircraft.
* ELECOM is not liable for any accident or social damages
 Laser sensor
incurred by the failure of this product.
Cautions for Laser Mouse
Though this product complies with the IEC60825-1 Class 1 laser safety
 Battery cover
standard to ensure safety, pay special attention to the following before use.
(1) Never observe the laser beam by using an optical measure such as
 Battery housing
a microscope or magnifier or view the laser with the naked eye for a
long period of time. Doing so may have an adverse effect on the eye.
(Some laser beams cannot be seen with the naked eye.)  Receiver unit housing
(2) Never aim the rear surface of the mouse at a person's eyes, as this is
very dangerous.
 Maintenance switch
(3) The laser sensor may not work on glass or mirrored surfaces.
(4) Do not use this product for any application other than as a PC mouse.
(5) If this product is subjected to temperatures beyond its specifications,
 USB connector (Male)
turn off the PC, and do not use the product until the temperature
returns to the operable range.
(6) If this product is not operating normally, turn off the PC.
Package Contents
y Mouse x1
Receiver unit x1
y
AAA alkaline battery x1
y
y User's Manual x1
Part Names
Mouse
 


 




Receiver unit

Scrolls back and forth to operate the PC.
S
Used for right-click operation.
Used for left-click operation
Indicates when to replace the batteries.
* When a battery has been inserted, if there are sufficient remaining
battery levels, it will illuminate in red for a certain period of time.
Flashes continuously when battery level gets low.
S
Used to turn the mouse body on and off
When the mouse body is moved, this sensor detects mouse
movement.
* Avoid looking directly at the light of the sensor as doing so may
cause eye damage.
This cover is removed to install batteries.
Batteries are inserted here.
Used to store the receiver unit.
For factory use only.
Connected to a PC USB port.
- 1 -
Preparation before Use
Installing·Replacing the Battery Inserting and Taking Out the Receiver Unit
Before using this product, install one AAA battery in the mouse body.
Inserting the receiver unit
„
Remove the battery cover.
Press part  firmly

to remove the cover
easily.
Insert the battery.
Make sure that the polarity is
y
correct.
Install the battery cover.
Click cover into place
„ Taking out the receiver unit
Turning On and Off the Mouse
„ Turning on the mouse
When using this product, turn the mouse body power on.
Slide the power switch to the ON position.
The remaining battery level indicator lamp is illuminated in red
for a certain period.
* Flashes continuously when battery level gets low.
Turning off the mouse
„
When not using this product, turn the mouse body off to save battery
power.
Slide the power switch to the OFF position
When using Windows®
1
Check USB ports S
tep tep
Check the USB port on your computer. Check that the mouse scrolls up and down correctly in Windows®
Internet Explorer.
USB port
Any USB port may be used.
y
This product can be connected to a USB hub. However, it may not
y
work depending on the power supply capability of the USB hub.
2
Installing the Receiver Unit
tep
Activate the PC.
y If Windows® prompts you to choose an account (a user name) when
it starts up, be sure to log on using an administrator account.
Wait until Windows® has started up completely.
y
Insert the receiver unit into the USB port of the PC
Insert here.
USB port
Receiver unit
Carefully check the orientation of the connector and the
y
place where you will connect the receiver unit.
If you feel strong resistance when inserting the receiver
y
unit, check that the shape and orientation of the connector
is correct. Using excessive force may damage the connector
and cause injury.
Do not touch the USB connector terminals.
y
The mouse driver is installed automatically.
Remove the battery cover.
Place the receiver unit into the
receiver unit housing.
Install the battery cover.
Click cover into place
Remove the battery cover.
Take the receiver unit out of the receiver
unit housing.
Install the battery cover.
3
Checking wheel operation
From the [Start] menu, select [All Programs], and then [Internet
Explorer].
Internet Explorer will launch.
Display your favourite web site in Internet Explorer and change
the size of the window so that the vertical scrollbar appears.
* The sample website used here is the ELECOM homepage.
Scrollbar
Scroll the wheel back and forth.
The mouse is operating normally if the screen moves up and
down as you scroll the wheel.
y In applications that do not support scrolling, the screen
will not move when you scroll the wheel.