Advertisement
Available languages
Available languages
TIME, DATE & CHRONOGRAPH FUNCTIONS
G
H
D
I
Fig. 1
L
K
J
M
Fig. 2
C
E
1 2
F
TIME, DATE & CHRONOGRAPH FUNCTIONS (fig. 1)
PUSHERS:
A. Chronograph start/stop
B. Split time, zero reset
TIMEPIECE INDICATIONS:
C. Hours
D. Minutes
A
SETTING THE TIME
1. Pull the crown out to position 3.
3
The seconds hand (E) will stop.
Remember the date advances
at 12.00 midnight, not 12.00 noon.
2. Turn the crown until the hands
indicate the desired time.
3. Push the crown back in to position 1.
B
SETTING THE DATE
1. Pull the crown out to position
(the watch will continue to operate).
2. Turn the crown clockwise until
the desired date is displayed.
3. Push the crown back in to position 1.
LIGHT FUNCTIONS (fig. 2)
PUSHER:
J. Activates the various light functions
LIGHT INDICATIONS:
K. Dial Illumination Mode:
LED in a choice of 8 colours
L. Extended Light Mode, Signal Mode
& SOS Signal Mode: white LED
M. Locator Mode & Battery EOL Mode:
red LED locator beacon
ACTIVATING THE LIGHT MODES
1. Dial Illumination Mode: press
J
pusher
to activate the coloured
LED (K), which will glow for
6 seconds.
Changing the colour of the LED (K)
a. When Dial Illumination Mode
is activated, press and hold
pusher
J
for 3 seconds to access
colour options.
b. Press pusher
J
to navigate between
the 8 possible colours.
c. Press and hold pusher
3 seconds to select the desired
colour.
E. Seconds
F. Date
CHRONOGRAPH INDICATIONS:
G. Seconds counter
H. 30-minute counter
I. Hours counter
Note: To avoid damaging
the movement, do not SET THE DATE
between 9.00 p.m. and 3.00 a.m.
when the date mechanism is in action.
USING THE CHRONOGRAPH
1. Press pusher
A
to start the
chronograph.
2. Press pusher
A
again to stop timing.
3. Read off results from the three
chronograph counters: HOURS (I) /
2
MINUTES (H) / SECONDS (G).
RESETTING THE COUNTERS TO ZERO
1. Press pusher B. The three
chronograph hands (G, H, I)
will return to zero.
2. Extended Light Mode: press pusher
twice in quick succession to activate
the white LED (L).
3. Signal Mode: press pusher
times in quick succession to activate
the white LED (L), which will flash
at 150 flashes/min. for 2 minutes.
Note: to deactivate Modes 1 / 2 / 3
before the 2 minutes has elapsed,
press pusher
J
once.
4. SOS Signal Mode: press and hold
pusher
J
for 5 seconds to activate
an intensified SOS light signal.
Repeat to deactivate.
5. Locator Mode: press pusher
five times in quick succession
to activate the red LED locator
beacon (M), which will flash
once every 10 seconds. Repeat to
deactivate.
6. Battery End-of-Life (EOL) Mode:
the red LED locator beacon (M)
will flash 3 times every 10 seconds
J
for
to indicate that the batteries
need replacing.
J
J
three
J
Advertisement
