Advertisement
Quick Links
Advertisement
Related Manuals for Victorinox Night Vision II
Summary of Contents for Victorinox Night Vision II
- Page 1 BASIC OPERATING INSTRUCTIONS NIGHT VISION II...
-
Page 2: Three Hand Analog Quartz
THREE HAND ANALOG QUARTZ NOTE: Refer to page 4 to determine what type of crown your timepiece has (pull-out or screw-down). SETTING THE DATE AND TIME A. Pull out the crown to position (2). B. Rotate the crown toward you until the date showing is the day before the desired setting. -
Page 3: Night Vision
NIGHT VISION II The Night Vision II makes use of Light Emitting Diodes (LEDs) for its flashlight and soft dial lighting. LEDs last longer than conventional incandescent bulbs, and are more durable and energy-efficient. Please note that the battery life of the lighting functions is significantly reduced with greater use. -
Page 4: Time And Date
TIME AND DATE To set time and date please refer to instructions for Three Hand Analog Quartz. Lighting Functions – Night Vision II 1. Dial Illumination Mode One quick push of the pusher will activate the soft LED light for 5 seconds. The angle of the light directs it to reflect off the crystal for maximum visibility of the dial and hands. - Page 5 3. Signal Mode Three quick pushes of the pusher will cause the light to strobe for 2 minutes. To deactivate, press pusher once. 4. Intense Signal Mode Holding the pusher for 5 seconds will activate an intensified LED strobe that flashes continuously. Intense Signal Mode is brighter than normal Signal Mode flashing.
- Page 6 Your Night Vision II timepiece has a built-in feature to protect battery consumption if the pusher used to operate the LED is accidentally pressed (for example in luggage or coat pocket, etc.). If the pusher is pressed for more than 30 consecutive seconds, the lighting feature will shut off automatically.
- Page 7 BATTERY Worn Batteries should be replaced immediately. Substituting interchangeable batteries is not recommended. Battery change should be performed by a qualified technician who should also check the condition of the gaskets and the o-ring at the same time. Battery is not covered by the warranty.