Sony HT-Z9F Operating Instructions Manual page 68

 When there is no picture from the
connected device or the picture from
the connected device is not output
correctly, set
Settings] - [HDMI Settings] - [HDMI
Signal Format] - [HDMI IN 1]/[HDMI IN
2] to [Standard format] (page 22).
 If you connect a device supporting
HDCP 2.2, be sure to connect the
device to the HDMI IN jack and the TV
to the HDMI OUT (TV eARC/ARC) jack
of the system.
 The system is connected to an input
device that is not HDCP (High-
bandwidth Digital Content
Protection) compliant. In this case,
check the specifications of the
connected device.
3D content from the HDMI IN 1/2
jack do not appear on the TV screen.
 Depending on the TV or video device,
3D content may not appear. Check
the supported HDMI video format
(page 81).
4K video content from the HDMI IN
1/2 jack do not appear on the TV
screen.
 Depending on the TV or the video
device, 4K video content may not
appear. Check the video capability
and settings of your TV and video
device.
 The picture may not be displayed
properly if the [HDMI Signal Format]
setting is changed. In this case,
change the setting to [Standard
format] (page 22).
 Use a Premium High Speed HDMI
Cable with Ethernet that supports
18Gbps or High Speed HDMI Cable
with Ethernet (page 81).
An image is not displayed on the
entire TV screen.
 The aspect ratio on the media is fixed.
68
GB
[Setup] - [Advanced
Picture and sound of the device that
is connected to the system are not
output from the TV when the
system is not turned on.
 Set
[Setup] - [Advanced Settings]
- [HDMI Settings] - [Control for HDMI]
to [On] on the system, and then set
[Standby Through] to [Auto] or [On]
(page 62).
 Turn on the system, and then switch
the input for the device playing.
 If connected to devices other than
those manufactured by Sony that
support the Control for HDMI
function, set
Settings] - [HDMI Settings] - [Standby
Through] to [On] (page 62).
HDR contents cannot show as high-
dynamic range.
 Check the settings of the TV and
connected device. For details, refer to
the operating instructions of your TV
and the connected device.
 Some devices may convert HDR
contents to SDR if the bandwidth is
not enough. In that case, set
[Setup] - [Advanced Settings] -
[HDMI Settings] - [HDMI Signal
Format] - [HDMI IN 1]/[HDMI IN 2] to
[Enhanced format] if the TV and the
connected device support a
bandwidth of up to 18Gbps (page 22).
When you select [Enhanced format],
be sure to use a Premium High Speed
HDMI Cable with Ethernet that
supports 18Gbps (page 81).
Sound
The system cannot connect to a TV
with the BLUETOOTH function.
 When you connect the system and TV
with the HDMI cable (supplied), the
BLUETOOTH connection is canceled.
[Setup] - [Advanced