Fcc Class B Notice - Tadpole SPARCbook 3000ST User Manual

FCC Class B Notice
FCC Class B Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your supplier or an experienced radio or television technician for help.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits.
Proper cables and connectors are available from your supplier. Tadpole Technology is not responsible for any
radio or television interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications to this equipment. Unauthorized changes or modifications to the
equipment could void the authority granted by the FCC to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE: To ensure compliance with the Class B limit, when this equipment is operated with an
external video monitor, the cable used to connect between this equipment and the external monitor must be of a
ferrite loaded type. If the cable used is not already fitted with ferrite cores, the user must install a split ferrite
core on the cable.
Canadian Department of Communications Compliance Statement
This equipment does not exceed Class B limits per radio noise emissions for digital apparatus set out in the
Radio Interference Regulations of the Canadian Department of Communications.
Avis de conformite aux normes du ministere des Communications du Canada
Cet equipment ne depasse pas les limites de Classe B d'emission de bruits radioelectroniques pour les appareils
numeriques, telles que prescrites par le Reglement sur le brouillage radioelectrique etabli par le ministere des
Communications du Canada.
SPARCbook Portable Workstation User Guide iii